Speaker
Mr
Holger Karstensen
(HUBER+SUHNER AG (CH))
Description
This activity focused on the development of ultra-light RF cables capable to handle RF power signals as considered for future telecom payloads. State of the art RF power cables have a serious limitation imposed by the poor thermal conductance from the inner conductor to the outside of the cable. This also implies poor phase stability which is an important requirement when combining amplifiers in reconfigurable or extremely high power payloads.
Considering the use of MPA, it is expected a large number of cable assemblies which implies a significant mass. Therefore, it was one of the major goals of this activity to reduce the mass of the cables in the order of 30-40% and also to meet more stringent requirements on phase stability as compared to currently available cables. The remaining RF parameters should not significantly be degraded.
Modelling tools were necessary for the prediction of the thermal, mechanical and RF performance of the cable assembly. Qualification models of the cable assembly have been designed, manufactured and tested.
The most challenging goal was to create suitable models for the phase stability behaviour of a cable, especially the extremely important dependence of the relative permittivity of the dielectric material on temperature and (temperature induced) mechanical stresses that occur in the cables, an effect that has been mostly neglected in previous studies. Samples had to be fabricated to prove the validity of the models, and suitable materials had to be found for the final design of the phase-stable cable.
A variety of engineering cable samples with different material combinations and various cable assembly concepts had been fabricated and characterised, until a cable design fulfilled the phase-stability requirements.
All parameters of the phase stable cable are within or better than the specified values. The final cable mass is extremely low (48 g/m) and the very stringent requirements on phase stability (<500ppm in the temperature range -55 and +125°C and <1000ppm between -55°C and 165°C) could be achieved after a variety of design and material changes.
Primary authors
Mr
Eden Sorolla
(LEMA/EPFL (CH))
Mr
Gerald Kress
(IMES/ETHZ (CH))
Mr
Koufogiannis Ioannis
(HUBER+SUHNER (CH))
Mr
Michael Mattes
(LEMA/EPFL (CH))
