Conveners
Evaluation and Qualification
- Dieter Herrmann (DLR)
Description
Evaluation and qualification of full custom ICs for space applications
Mr
Art Schaldenbrand
(Cadence Design Systems)
18/06/2018, 14:00
Implementation of Radiation Hardening on analogue circuits at cell-, circuit-, and system design level
Oral
Device reliability analysis has evolved little since the release of BERT in 1989, yet the expectations of circuit reliability have changed. While it would be easy to say that the requirements for automotive reliability are the sole factor driving this change, the expected reliability for every application have increased. The average car does not have to sustain the 24 hour a day, 7 day a week...
Mr
Alain Van Esbeen
(Thales Alenia Space Belgium), Mr
Marc Fossion
(Thales Alenia Space Belgium)
18/06/2018, 14:25
Needs and Requirements for analogue and mixed-signal ICs in future space missions
Oral
The presentation covers the lessons learned from introduction of the Digital Programmable Controller ASIC (DPC) into several space products. Full benefit of DPC introduction, like decentralization of equipment management, is currently limited by size & cost of the component, the latter being a key factor for constellations. Alternative packaging trade-offs will be discussed: a non-hermetic BGA...
Mr
Fernando Martinez
(ESA)
18/06/2018, 14:50
Evaluation and qualification of full custom ICs for space applications
Oral
As advanced at previous communications at AMICSA 2012 and 2016, the
European Space Components Coordination (ESCC) system has evolved in recent
years in order to adapt its methodologies for Qualification. The most
recent developments of possible interest for the AMICSA community may be:
- the recent approval by the ESCC Policy and Standards Working Group of a
so-called Single Phase...
Mr
Servando Espejo
(IMSE-CNM-CSIC / Universidad de Sevilla)
18/06/2018, 15:15
Custom cell-, circuit-, and system design of ICs for space applications
Oral
The paper describes the final characterization results of the MEDA-WS ASIC, which was described in a previous paper in AMICSA-2016. It describes as well the qualification and the screening processes that have been carried out, and the present status of its integration and calibration in the final engineering and flying modules of the wind-sensor instrument.
Specific details include to the...
